MDC2
VISIÓN GENERAL
MoTeC’s Mitsubishi Diff Controllers (MDC and MDC2) are suitable for Mitsubishi Lancer Evo models. They replace the factory fitted Active Centre Diff (ACD) controller as a bolt-in replacement making use of the factory mounting points under the dashboard. The MDCs can be used in vehicles fitted with the ACD/AYC (Active Yaw Control), but the AYC will be disabled.
Functionality
The MDC is used to adjust the torque split between the front and rear differentials to achieve greater control over handling characteristics such as traction, braking on loose surfaces, turn-in response, and understeer on both corner entry and exit.
The centre differential is essentially a limited slip differential with adjustable preload. The preload is proportional to the fluid pressure in the centre differential. The MDC works by regulating solenoid current, which in turn, controls the fluid pressure. When no pressure is applied (0% lock) the centre differential operates as an ‘open diff’. With increasing fluid pressure (increasing percentage lock) the preload increases, requiring more torque difference between front and rear wheels before the centre differential will slip.
There are six selectable control modes: 0% lock, 100% lock and four user-configurable modes. These modes can be cycled through using the factory dash mounted ACD button.
ESPECIFICACIONES BASICAS
Communications
- 1 x CAN
- 1 x RS232
Physical
- Connector: 2 x Connectors fitting directly into factory wiring
- 1 x 26 pin
- 1 x 22 pin
- Case size: 111 x 83 x 31 mm, excluding mounts
COMPATIBILIDAD
MoTeC’s Mitsubishi Diff Controller (MDC2 #14016) is suitable for:
- Mitsubishi Lancer – Evolution X (RS)
CARACTERISTICAS
- 6 x Selectable control modes:
- 1 x 0% lock mode
- 4 x user-defined modes
- 1 x 100% lock mode
- Control modes can be selected using the dash mounted ACD button.
- Each mode is configurable with an acceleration table, braking table and desired slip table.
- The percentage lock can be configured using vehicle speed and throttle position. With the MoTeC Plug-In ECU connected, engine efficiency point can be used instead of throttle position. The ECU will calculate and then send the efficiency point to the MDC. This feature uses the factory wiring loom.
- With the RS232 serial communications configured, the MDC can send wheel speeds, lateral G-force, longitudinal G-force, steering position, diff parameter and fault codes to the MoTeC M800 Plug-In ECU without the need for additional sensors.
- The CAN interface optionally transmits the sensor and diagnostic information to a MoTeC Dash Logger.
- Handbrake override.
ACESORIOS
For configuration and upgrading of firmware connect to a laptop using the MoTeC UTC (USB To CAN) adaptor.
- 61059 – UTC – USB TO CAN PLUS CABLE